MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 14)

12
Playback
Setting Up Your VCR to Playback/Recording the
Digital Broadcast in D-VHS Format
1 Make sure that your VCR and the integrated HDTV or the IEEE 1394-equipped
HDTV receiver is connected with an IEEE 1394 cable.
2 Turn on the IEEE 1394-equipped HDTV receiver.
3 Turn on your TV and switch the input of the TV to the correct input of the IEEE
1394-equipped HDTV receiver.
4 Press POWER on the VCR to turn the power on.
To go back to viewing the picture from the TV, set your TV input to the previous
ANTENNA input position.
If you do not switch the integrated HDTV or the IEEE 1394-equipped HDTV re-
ceiver to the correct external input, the screen to the right will be displayed on the
screen when you try to watch a digital broadcast.
1394 connection list
When you connect an integrated HDTV, an IEEE 1394-equipped HDTV receiver or
a D-VHS VCR to the HS-HD2000U, you can see the list of connected TV, receiver
or VCR on the 1394 connection list menu (up to 5 devices). The integrated HDTV
and the IEEE 1394-equipped HDTV receiver will display as TUNER and the D-VHS
VCR will be shown as VCR. For the device which was connected to the HS-
HD2000U before but now it is not connected, lost connection will be displayed.
The device which was first connected to the HS-HD2000U will be shown as d1,
and connected fifth will be shown as d5. When you want to remake the list, press
CANCEL on the VCR remote control. In this case, the order of the devices on the
list will be changed.
IMPORTANT
When you connect Mitsubishi integrated HDTVs WS-55859, WS-65869, WS-
55909, WS-65909 or WS-73909, they will not appear in 1394 connection list
menu. When you use these TVs, they will control the HS-HD2000U. So to
use the function of the HS-HD2000U, use the TV to operate the VCR.
displaying 1394 connection list
1 Press MENU on the remote control. VCR Main Menu comes up.
2 Turn the ADJUST dial on the remote control to select 1394 connection list.
Turn the shuttle ring to the right. 1394 connection list menu appears.
Setting Up Your VCR to Playback/Recording the
Tape in Analog (S-VHS/S-VHS ET/VHS) Format
The first thing you need to do is set up your VCR so that you can see the picture
coming from the VCR. It’s important to take a few minutes to set up your VCR
correctly before you try to use it. Based on the type of TV that you have, choose
one of the following:
TV with Audio/Video Inputs
1 Turn on your TV and switch it to the correct external input. For most Mitsubishi
TVs, this means pressing the TV’s INPUT button until you see the words Ext-1
or Input-1 on the screen. If you do not have a Mitsubishi TV, please refer to
your TV Owner’s Guide for this procedure.
2 Turn the VCR on by pressing POWER.
VCR POWER
IEEE 1394
INPUT
PWR. HS STD VCR
H M S
ƒ1394 connection list
d1 TUNER lost connection
d2 TUNER lost connection
d3 TUNER now connecting
d4 VCR now connecting
Press CANCEL to renumber
Use ADJUST to select,
and ENTER.
Press MENU to go back.
This is a digital
recording.
You cannot view it
through this input.
Please select IEEE1394
connection.