MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 40)

38
When you program both the D-VHS and analog timer recording
When you turn the VCR off, the programmed recording light will appear on the front
panel display, showing that the VCR is in stand-by mode for the analog timer
recording. In this mode, the D-VHS timer recording you have set may not be
recorded depending on the integrated HDTV or IEEE 1394-equipped HDTV
receiver that you are using. (Refer to your TV or receiver owner’s guide for the
details.) If so, you need to press POWER on the VCR front panel once to cancel
the stand-by mode when the D-VHS timer recording is activated. When you press
POWER, the programmed recording light will be turned off but the VCR power will
remain off. Please note that the VCR cannot activate the analog timer recording
while the programmed recording light is turned off.
When the D-VHS timer recording is over, press POWER on the front panel twice to
turn on the programmed recording light.
Analog (S-VHS/S-VHS ET/VHS) Timer Recording
of Digital Broadcast
IMPORTANT
Be sure to connect the VCR and an integrated HDTV or an IEEE 1394-
equipped HDTV receiver with an S-video/video and an audio cable to record a
digital broadcast in analog format.
1 Select the Front S-input in the S-VHS Set-UP menu when you connect an
integrated HDTV or IEEE 1394-equipped HDTV receiver to the front panel of the
VCR, or Rear S-input when you connect an integrated HDTV or IEEE 1394-
equipped HDTV receiver to the rear of the VCR. See Selecting S-input
Setting on page 33.
2 Select the channel you would like to record on an integrated HDTV or an IEEE
1394-equipped HDTV receiver, not on the VCR.
3 Load a tape with its erasure prevention tab intact into the VCR.
4 Press MENU. VCR Main Menu appears on your screen. Turn the ADJUST
dial to select Program to record. Turn the SHUTTLE ring to the right.
If there is at least one programmed recording already entered, you will see the
Recap screen. Wait 4 seconds, and the VCR Plus+ system menu will appear.
IMPORTANT
If you have already programmed 8 recording events, Program memory is full
will appear on your screen for 3 seconds, and then the Recap screen will
appear. Use CANCEL to erase an entry before you can add another one.
5 VCR Plus+ system menu appears. See page 42 to learn how to program with
VCR Plus+ system. To pass this screen, turn the SHUTTLE ring to the right.
Timer Recording
ªVCR Main Menu
¬Program to record
ƒ1394 connection list
√Customize choices
»S-VHS Set-Up
ƒFirst Time Set-Up
Use ADJUST to select,
and ENTER.
Press MENU to exit menus
¬VCR Plus+ system
Use number keys to enter
the PlusCode number
--------
or press ENTER to
program.
Press MENU to go back.
¬Program to record
CH DAY ON OFF
10 TH15 9:00a10:30pSP
§--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
--- -- --:-- --:-- SP
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.
Recap screen