Editing features, Copying a tape from d-vhs to d-vhs – MITSUBISHI ELECTRIC HS-HD2000U User Manual
Page 53
51
Editing Features
IEEE 1394
INTERFACE
HS-HD2000U
ANOTHER D-VHS VCR
IEEE 1394
INTERFACE
IEEE 1394
INTERFACE
1
Connect an IEEE 1394 cable to IEEE 1394
INTERFACE on the playback VCR and to IEEE
1394 INTERFACE on the HS-HD2000U. You can
use either of the two IEEE 1394 INTERFACE
terminals.
IMPORTANT
Do not pull out an IEEE 1394 cable during
copying the tape.
You cannot copy a tape in D-VHS format from
digital video equipment (for example, digital
video camera) even if it is connected with an
IEEE 1394 cable.
2
Set the recording VCR to be able to control the
playback VCR.
To do this, when you use HS-HD2000U as a
recording VCR, press IEEE 1394 INPUT on the
remote control to display d1 to d5 on the front panel
which will correspond to the D-VHS VCR used as a
playback VCR. If you use this VCR as a playback
VCR and the other VCR as a recording VCR, refer
to the recording VCR owner’s guide for this
procedure.
3
Put a D-VHS tape with the erasure prevention tab
intact to the recording VCR.
4
When you are using the HS-HD2000U as a
recording VCR, make sure that the D-VHS button on
the front panel is lit. If it is not, press the button to
light it up.
5
Put the tape you want to copy into the playback VCR
and find the cue point. Press STOP if the picture
starts playing.
IMPORTANT
As it will take a few seconds to automatically
select the recording mode, stop the tape slightly
before the point you want to start copying.
6
On the playback VCR, press PLAY, then PAUSE.
7
On the recording VCR, press REC, then PAUSE.
8
Press the PAUSE buttons on both VCRs at the same
time to begin copying the tape.
9
When finished, press STOP on both VCRs.
IMPORTANT
The programs prohibited from copying or the
programs with copy restriction cannot be copied
correctly. When you use the HS-HD2000U as a
recording VCR and copy such programs, Error
CP appears on the front panel display.
Copying a Tape from D-VHS to D-VHS
When you connect a D-VHS VCR equipped with IEEE 1394 INTERFACE terminal to the HS-HD2000U with an IEEE
1394 cable, you can copy a tape from D-VHS format to D-VHS. You cannot edit the tape while copying from D-VHS to
D-VHS.