MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 61)

59
repeat playback
You can playback a section of tape over and over using repeat playback. The tape
will play until the next index mark, rewind to the previous index mark, and resume
playing. If there is only one index mark on the tape, then the VCR will play or
rewind to that mark and resume playback. If there is no index mark, the entire
cassette will repeat.
1 Press VIDEO on the remote control to display the video function menu. Press
VIDEO until the Repeat play function appears.
2 To start the playback, turn the SHUTTLE ring to the right.
When the VCR encounters the next mark or the end of the tape, it will
automatically rewind to the previous mark and begin playback again.
The VCR will also search for a blank section of the tape. If the VCR
encounters any blank sections longer than 4 seconds in length, the repeat
playback will begin.
3 Press STOP to cancel the repeat.
IMPORTANT
For the tape recorded in D-VHS format, repeat playback may not work
correctly depending on the recording condition.
Search to blank
This feature allows you to find the end point of the recorded part of the tape. The
VCR will stop automatically at the beginning of the blank section of a tape.
1 Press VIDEO on the remote control to display the video function menu. Press
VIDEO until the Search to blank function appears.
2 To start the search, turn the SHUTTLE ring to the right.
When the VCR encounters the blank section of a tape, it will automatically
stop.
IMPORTANT
This feature may not work if the blank section is 5 minutes or less apart in HS
mode, 10 minutes or less in STD mode, 5 minutes or less in SP mode or 15
minutes or less in EP mode.
Displaying the Time Gauge and the Remaining Time
The time gauge is a graphic representation of your position on a video tape. The
left side of the gauge is the tape start (S), and the right side is the tape end (E).
For a T-120 length tape played at standard (SP) speed, each mark on the gauge
represents about 15 minutes. The remaining time display shows the time, in hours
and minutes, left until the end of a tape.
the time gauge and the remaining time automatically appear during:
fast forward and rewind (from a stopped tape)
counter zero stop
index searches
rewinding for repeat playback
search to blank
Turn off the time gauge and the remaining time by pressing DISPLAY twice.
to make the time gauge and the remaining time appear:
Press DISPLAY once. The time gauge and remaining time appear on the TV
screen, and the remaining time appears on the front panel display. They disappear
after 4 seconds when playing a tape.
To turn off the display, press DISPLAY twice.
VCR
Stop
⁄‡‚‡‡‡‡‡‡‹
REM 1:40
0h20m08s
Time gauge
Remaining time display
PWR. SP
CH
VCR
L R
Remaining time display
(This screen appears during
analog playback only.)
Advanced Features
VCR
Repeat play
Use ENTER to start
VCR
Search to blank
Use ENTER to start