MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 22)

20
IMPORTANT
Automatic channel programming using A LL S ET may include vacant channels
if there are stray signals or noise on those channels. If this occurs, you can
manually delete the channels using the procedure in the section Adding and
Deleting Channels.
You do not need to perform this set-up again unless your cable company
changes their channel lineup, or you move the VCR to a new address.
After a power failure, if you have set Clock set within the Set the clock menu
to AUTO, then A
LL S ET will automatically set the clock again.
Once the VCR has completed the A LL S ET set-up, it can automatically set the
clock, including your time zone and daylight saving time. In order for the
auto clock function to work, the Clock set within the Set the clock menu must
be set to AUTO. Follow ALL the steps in Setting the Auto Clock.
Satellite Receiver Control
If you are using a satellite receiver, you can set up your VCR to change channels
on the satellite receiver.
1 Make sure you are viewing the picture coming from your VCR. Press MENU
on the remote control. VCR Main Menu appears.
2 Turn the ADJUST dial on the remote control to select First Time Set-Up. Turn
the SHUTTLE ring to the right.
3 You will see the First Time Set-Up menu. Turn the ADJUST dial to select Sat.
receiver.
IMPORTANT
You cannot select Sat. receiver if you select Digital Cable box only in step 4
of A
LL S ET (on page 17).
4 Turn the SHUTTLE ring to the right to select the correct code for your satellite
receiver.
Manufacturer Code
GE 1
RCA 1, 8
PRIMESTAR ® 2
Sony 3
DISH Network 4
Toshiba 5
Panasonic 6
Mitsubishi/Hughes 7
none OFF
5 After you have selected, press MENU twice to exit the menus.
IMPORTANT
After you have connected the satellite receiver and set the brand code, you
need to see if your VCR can control your satellite receiver. To do this, use
CHANNEL or number buttons on the VCR remote to tune to a satellite
channel. If the satellite channels appear on your TV, then your VCR can
control your satellite receiver.
Setting Up Your VCR
ƒFirst Time Set-Up
∆AllSet
≈Set the clock
«Add/delete channels
±Sat.receiver (OFF)
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER to change.
Press MENU to go back.