MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 62)

60
IMPORTANT
The time gauge and remaining time work by detecting control signals on
recorded tapes. Therefore they do not function while playing blank tapes.
The remaining time display may not show the correct remaining time if the Tape
function is incorrectly set, if you are using speed search, if you are using a special
length cassette (such as T-10 length), or if you are using an S-VHS-C or a VHS-C
tape with an adapter.
The remaining time display may not work correctly depending on your tape.
Displaying the Current Time
The current time is shown in the front panel display or the TV screen. If you have
not set the clock, or if there has been a power failure of longer than 30 minutes, the
display will show - - : - -. The current time will be displayed when the VCR is off.
To see the current time when the VCR is on:
1 Press DISPLAY twice. The counter will be replaced by the current time.
2 To turn off the current time, press DISPLAY again.
Customize Choices Menu
In the Customize Choices menu, there are 7 options that you can set. For each of
the 7 options, start with these 2 steps:
1 Press MENU on the remote control. VCR Main Menu appears on your TV.
2 Use the ADJUST dial on the remote to select Customize choices. Turn the
SHUTTLE ring to the right.
IMPORTANT
Customize choices menu consists of two pages. To display the next page,
use ADJUST dial to select Go to next page and turn the SHUTTLE ring to the
right. To go back to the previous page, use ADJUST dial to select Back to
previous page.
Video mute
When you turn video mute ON, any blank section of tape or many stations with a
weak signal will be replaced by a blue screen. The sound will also be turned off.
When you would like to try to tune in on a weak station, turn video mute OFF.
3 Complete steps 1 and 2 above. Customize choices menu appears. Use the
ADJUST dial to select Video mute. Turn the SHUTTLE ring to the right to set
video mute to ON or OFF.
4 Press MENU twice to exit the menus.
IMPORTANT
Video mute function may not work properly when you playback a section of a
tape where only audio signals are recording.
Advanced Features
VCR
Stop
⁄‡‚‡‡‡‡‡‡‹
Sun 8:30p
0h20m08s
Current time display
PWR.
PM
SP
CH
VCR
L R
Current time display
(This screen appears during
analog playback only.)
ªVCR Main Menu
¬Program to record
ƒ1394 connection list
√Customize choices
»S-VHS Set-Up
ƒFirst Time Set-Up
Use ADJUST to select,
and ENTER.
Press MENU to exit menus
√Customize choices
ƒVideo mute (ON )
ƒAuto power save (OFF)
ƒRF converter (OFF)
ƒPerfecTape (AUTO)
Go to next page §
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER to change.
Press MENU to go back.
√Customize choices
ƒVideo mute (ON )
ƒAuto power save (OFF)
ƒRF converter (OFF)
ƒPerfecTape (AUTO)
Go to next page §
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.
√Customize choices
ƒRentalXpress (OFF)
ƒSearch w/ Picture(OFF)
Back to previous page §
ππππππππππππππππππππππππ
Use ADJUST to select,
and ENTER.
Press MENU to go back.