MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 46)

44
IMPORTANT
You cannot transfer the PlusCode number while the VCR is recording or on
recording pause mode.
If the VCR memory is full, Program memory is full will appear for 8 seconds,
and then the Recap screen will appear. Use CANCEL to erase an entry
before you can add another one.
If the code number you entered is wrong, The PlusCode number is not valid
will display on the screen for 8 seconds, and then the VCR Plus+ system
menu will appear.
If two programmed recording times overlap, VCR is already programmed for
that time will display on the screen for 8 seconds. You will need to erase the
previous program before you can enter the new one.
If the remote control has failed to transfer the data, The transfer has failed.
Please transfer again will be displayed on the screen for 8 seconds. To
transfer the same PlusCode number again, press TRANSFER twice.
Pressing TRANSFER once displays the PlusCode number on the remote
control LCD again, and pressing it again transfers the displayed PlusCode
number.
7 To program additional recording times, follow the procedure from step 2 to 6
again.
8 When you are finished with all programming, check the following:
• If you have a cable box, a digital cable box, a PRIMESTAR
® or a DISH
Network ™ satellite receiver, leave the cable box or receiver turned ON.
• If your VCR does not control your cable box, leave the box tuned to the
station you wish to record.
• Turn the VCR power OFF and make sure the programmed recording light is
lit.
IMPORTANT
To cancel VCR Plus+ System Programming while programming with the
remote control LCD, press VCR Plus+.
To cancel VCR Plus+ System Programming while displaying the Recap
screen, press CANCEL to cancel the selected program, and then press
MENU to exit the Program to record.
Timer Recording