Integra DSR-7.3 - Manual (Page 21)

21 21
Operating Components not Reached by
the Remote Controller Signals (IR IN)
In order to use the remote controller to control the DVD
Receiver from a remote location, you will need to prepare a
multi-room kit (sold seperately) such as one if those given
below:
IR IN
DSR-7.3
In the
cabinet
Remote Controller
Connecting
block
IR Receiver
: Signal flow
• Onkyo’s Multi-Room System kits (IR Remote Controller
Extension System), or
• Multiroom A/V distribution and control systems from Niles ®
and Xantech ® to name a few.
If the remote controller signal does not
reach the DPC-5.3 remote sensor
If the DVD Receiver is located inside a cabinet or other
enclosure where the infrared rays from the remote controller
cannot enter, then operation with the remote controller will not
be possible. In such a case, it will be necessary to install a
remote sensor at a location outside of the cabinet for the
infrared rays from the controller to reach. The IR IN input allows you to control the DVD Receiver from
the remote zone with the remote controller even though the
remote zone may be on the other side of the building from the
main zone. The diagram below shows how to make the prober
connections for the remote zone.
AC INLET PREOUT
SUB
WOOFER TV/LINE MD/CDR/TAPE
DIGITAL
OPTICAL
AUDIO
REMOTE
CONTROL
AM FM 75
SURROUND
SPEAKERS FRONT SPEAKERS
CENTER R L
IN
IN IN OUT
L
R
R L
OUT
ANTENNA
VIDEO OUTPUT
S VIDEO VIDEO COMPONENT
Y P B P R
IN
IR
Mini plug cable
From the connecting block
to IR IN
DSR-7.3
Main room Remote zone
Remote Controller
Connecting
block
IR Receiver
: Signal flow
If the remote controller signal does not reach the DVD Receiver