Integra DSR-7.3 - Manual (Page 26)

26 26
Speaker Setup
You need to set up the speaker configuration for the speaker
system connected to the SPEAKERS connectors
(see page 17).
Notes
• Speaker setup cannot be done if;
– Headphones are connected (see page 40)
• It is not necessary to set the parameters again once you have
completed the setup unless you change the speaker
configuration.
Selecting the number of speaker
channels
Note
To check the present setting while the normal display is displayed,
press SP Setup once. To change the setting, press the button
repeatedly within three seconds.
Remote controller
only
SP Setup
1
Send
On Standby
Op en/ Clos e
2
T- D Setup IPM
SW Mode Distance
T-D/ ST
A- B
Surround A.Control
-- / ---
Mode
Enter
Repeat
Muting
Up/ Down
SP Setup Test Tone CH Sel
RC- 507M
Audio
Last M Program Random
Late Night Timer
Angle
Clear
Subtitle FM Mode
Input Selector
ENTER
Light
TV
Display
VOL C H
T V In pu t Setu p
DV D Recvr Tape
Tun
Step/ Slow
To p M enu Men u
Retu rn
Clo ck Sle ep
Dimm er
1 2 3
4 5 6
+10 Search 0
7 8 9
SW Mode
SP Setup
Selecting the Subwoofer mode
Before operating the
remote controller
Press Mode Recvr.
Press SW Mode on the remote
controller.
With the first press of the button, you can
check the present setting. Then each
press of the button changes the subwoofer
mode as follows (a tip on how to select the
right subwoofer mode is in parentheses):
SW Mode 1 (Factory setting)
(When small–with limited bass signal
handling–front speakers are
connected)
↓
SW Mode 2
(When large–wideband–front speakers
are connected)
↓
SW Mode 3
(When large–wideband speakers are
connected to all channel)
↓
SW Off
(When no subwoofer is connected)
The normal display resumes in three
seconds.
Remote controller
only
SW Mode
4
Press SP Setup repeatedly to select
the number of channels for the
SPEAKERS system.
Pressing the button repeatedly within three
seconds changes the number of channels
as follows (the corresponding speaker
configuration is described in parentheses):
Speaker 5 ch (Factory setting)
(Front left, center, and right, plus
surround left and right speakers)
↓
Speaker 2 ch
(Front left and right speakers)
↓
Speaker 3 ch
(Front left, center, and right speakers)
↓
Speaker 4 ch
(Front left and right, plus surround left
and right speakers)
The normal display resumes in three
seconds.