Integra DSR-7.3 - Manual (Page 45)

45
Switching the timer on or off
• Use when you want to cancel an active timer setting, reset
a canceled timer, or when you want to revise a record
timer.
• If the current time is not set, you cannot preset the timer.
Repeatedly press Timer to select
the desired timer type.
The Timer indicator at the top of the display
lights up when the respective timer is set.
Use ( 5/∞) to switch the timer on or
off.
Approx. 2 seconds after switching the
timer, the previous screen will reappear.
Caution
Pressing ENTER, activates the start time (etc.)
setting mode.
or
» » » »
WEEKDAY
Active
REC
Canceled
WEEKEND
on off on off
Active
Time 9:00 10:00 11:00 12:00
Send
On Standby
Op en/ Clos e
2
T- D Setup IPM
SW Mode Distance
T-D/ ST
A- B
Surround A.Control
-- / ---
Mode
Enter
Repeat
Muting
Up/ Down
SP Setup Test Tone CH Sel
RC- 507M
Audio
Last M Program Random
Late Night Timer
Angle
Clear
Subtitle FM Mode
Input Selector
ENTER
Light
TV
Display
VOL C H
T V In pu t Setu p
DV D Recvr Tape
Tun
Step/ Slow
To p M enu Men u
Retu rn
Clo ck Sle ep
Dimm er
1 2 3
4 5 6
+10 Search 0
7 8 9
Timer
Standby
5/∞
• If WEEKDAY timer end time and the REC timer start time
are set to the same time, the REC timer will not activate.
Please all a one-minute difference end time and start time
of each times.
• If two or more ONCE / WEEKDAY / WEEKEND / REC are
set to the same timers start times are given the following
priority: ONCE
→ WEEKDAY → WEEKEND → REC.
• If the REC timer is deactivated because the power is
already on (etc.), the TIMER indicator does not light in the
display and the timer settings are cancelled.
• If the power is already on when a timer’s start time occurs
and there is another overlapping timer, the second timer
will not operate. The power turns off automatically at the
end time of the first timer.
8
1
2
Standby
Timer
ENTER
ENTER
ENTER
«
7-2
■ In the case of overlapping timer settings
• When the power is turned on during timer playback, even if
you set another timer, it will not be activated. The initial
timer is canceled when the standby mode is initiated.
EVERY recording:
Set the day.
To change the day of week setting:
Press ( 2/3) so that the desired day blinks.
Press ( 5/∞) to select/deselect the day.
Press ENTER to confirm the setting.
The timer indicator lights up.
Set the power to Standby.
Press Standby to put the system into
standby mode.
• The muting function activates during
timer recording. If you would like to
monitor the sound during recording,
press Muting on the remote to cancel
the muting function.
Caution
• Even if the record timer is set to sure the
timer, the timer will not operate unless the
power is set to the standby mode. Make sure
the system is in standby mode.