Integra DSR-7.3 - Manual (Page 57)

57
Exit Move
Current: Title
Title
Program Memory On
7
1
Chapter
(Chapter 1~18)
1
Program Chapter Program Title
Off
PROGRAM ENTER Select
■ To save a program in memory
This DVD Receiver can memorize the programs on up to 24 DVDs.
By turning the [Program Memory] to [On], the DVD Receiver will save
your program and recall it the next time you use the same DVD.
When the program memory exceeds 24, programs will be erased in
chronological order from the oldest program in memory.
1 Use the cursor button ( ∞) to highlight [Program Memory]
and use the cursor button ( 3) to select [On].
2 Press ENTER.
The program is saved in memory.
Note
When a DVD with a program stored in memory is loaded, program
playback may start automatically.
■ To erase a program saved in memory
The DVD receiver erases programs in chronological order when the
maximum number of programs that can be held in memory is
exceeded. To prevent the DVD receiver from erasing older programs
that you may still use regularly, or when you don’t want to use a
program anymore, it is possible to manually erase programs stored
in memory.
1 Load a DVD that has a program stored in memory.
2 Press Program.
The program screen appears.
3 Use the cursor button ( ∞) to highlight [Program Memory]
and use the cursor buttons ( 3/∞) to select [Off].
4 Press ENTER.
The program is cleared from memory.
If you press Clear in stop mode, the program will be cleared from
memory and [Program Memory] will be turned to [Off].
Programming Video CDs, CDs
VCD CD
Exit Move Play
Current: Track
Total Time
1(/10)
0.00
Program Track
PROGRAM ENTER
A program with a maximum of 24 steps can be memorized.
Press Program.
The program screen appears. When a
Video CD or CD is loaded, the cursor
appears in the program window.
Use the number buttons to enter the
numbers of the tracks in the order
you want to program them in.
• To program tracks 9, 7, and 18 in order,
press 9, 7, +10 and 8.
• To edit the program, refer to the
procedures on the previous page.
Press ENTER or £.
• Playback starts in the specified track
order.
• Press PROGRAM to return to the
previous display. The program play will
not begin until
£ is pressed.
• To stop the program play, press 7.
Note
You cannot program when playing a Video CD using menu
selections (during PBC).
1
2
3
Program
T- D Setup IPM
SW Mode Distance
-- / ---
Up/ Down
SP Setup Test Tone CH Sel
1 2 3
4 5 6
+10 0
7 8 9
ENTER
Number
buttons
Send
On Standby
Op en/ Clos e
2
T- D Setup IPM
SW Mode Distance
T-D/ ST
A- B
Surround A.Control
-- / ---
Mode
Enter
Repeat
Muting
Up/ Down
SP Setup Test Tone CH Sel
RC- 507M
Audio
Last M Program Random
Late Night Timer
Angle
Clear
Subtitle FM Mode
Input Selector
ENTER
Light
TV
Display
VOL C H
T V In pu t Setu p
DV D
Recvr Tape
Tun
Step/ Slow
To p M enu Men u
Retu rn
Clo ck Sle ep
Dimm er
1 2 3
4 5 6
+10 Search 0
7 8 9
2/3/5/∞
ENTER
£
7
Clear Program
Before operating the
remote controller
Press Mode DVD.