Integra DSR-7.3 - Manual (Page 28)

28 28
2
Adjusting Each Speaker's Relative Volume Balance – Test Tone
Adjust each speaker’s relative volume balance so that the
volumes of all speakers’ test tones sound equal at the
listening position.
Note
You cannot adjust the volume balance while the muting function is
activated.
When you have completed the
adjustment by repeating step 2,
press Test Tone.
The test tone stops and the normal display
resumes.
When test tone adjustments are
completed, return the volume to its usual
level.
Note
Even if you don’t press Test Tone, the test tone
will stop after two minutes.
1
Remote controller
only
3
«
Test Tone
2
Up/ Down
6
9
Send
On Standby
Op en/ Clos e
2
T- D Setup IPM
SW Mode Distance
T-D/ ST
A- B
Surround A.Control
-- / ---
Mode
Enter
Repeat
Muting
Up/ Down
SP Setup Test Tone CH Sel
RC- 507M
Audio
Last M Program Random
Late Night Timer
Angle
Clear
Subtitle FM Mode
Input Selector
ENTER
Light
TV
Display
VOL C H
T V In pu t Setu p
DV D Recvr Tape
Tun
Step/ Slow
To p M enu Men u
Retu rn
Clo ck Sle ep
Dimm er
1 2 3
4 5 6
+10 Search 0
7 8 9
Test Tone
Up/Down 5/∞
CH Sel
Before operating the
remote controller
Press Mode Recvr.
CH Sel
3
Test Tone
2
Press Test Tone.
Each speaker emits the test tone (pink
noise) and the display shows the speaker
emitting the test tone in the following
order:
LEFT
→
CENTER
(Front left ch.) (Center ch.)
↑ ↓
SUBWFR RIGHT
(Subwoofer) (Front right ch.)
↑ ↓
SURR L
←
SURR R
(Surround left ch.) (Surround right ch.)
Set voume at a level for easy comparison
of all speakers’ output.
Note
No test tone will be emitted from a speaker
which is not included in the speaker
configuration on pages 26 even if it is actually
connected.
Press CH Sel repeatedly to select
the speaker, then press
Up/Down
5/∞ to adjust the volume
level.
The volume level can be adjusted between
–12dB and +12dB.
Speaker Setup