Integra DSR-7.3 - Manual (Page 24)

24 24
Connecting the Power/
Turning on the DVD Receiver
Before connecting
• Make sure that all the connections from pages 16 to 23 are
complete (the connection to the TV is required).
• Turning on the DVD Receiver may cause a momentary power
surge, which might interfere with other electrical equipment such
as computers. If this happens, use a wall outlet on a different
circuit.
1
Standby indicator Display
On indicator
Standby/On
3
■ Setting the Clock Display
To display the clock while in Standby mode, hold down the
Standby/On button for at least 2 seconds while the unit is in On
mode.
Note
Displaying the clock in Standby mode consumes the same amount of
power as in the On mode.
to wall outlet
Remote
Controller
Unit
On
On indicator
Standby indicator
Connect the power cord to the AC
INLET of the DVD Receiver.
Connect the power cord to a wall
outlet.
The DVD Receiver enters the standby
mode and the Standby indicator lights up.
Press Standby/On on the DVD
Receiver or On on the remote
controller to turn on the DVD
Receiver.
The light and display on the DVD
Receiver’s front panel light. At the same
time, the Standby indicator goes off and
the On indicator lights up.
• To put the DVD Receiver in the standby
mode, press Standby/On on the DVD
Receiver, or Standby on the remote
controller. Be sure to set the volume to
minimum before putting the DVD
Receiver in the standby mode for the
next use to avoid sudden loud sound
reproduction.
• While in the Standby mode, the DVD
Receiver can receive signals from the
remote controller.
• Setting the Standby button on the
Remote controller to standby does not
shut off the power completely.
AC INLET
2
AC INLET