Integra DSR-7.3 - Manual (Page 36)

36
Listening to the Radio
Naming a Preset Station
You can name the preset stations so that the name, instead
of the frequency, appears on the display when you select the
station. The following 52 characters can be used:
(space) ABCDEFGHIJKLMNOPQUSTUVWXYZ” ’&()[ ]*+,-./
=?0123456789
1
FM Auto Preset Memory
This function enables you to store the frequencies into
memory automatically, without having to go through and
store each frequency manually.
Hold down the Preset Memory
button for a few seconds. “AUTO
MEM” will start flashing on the
display. Keep holding down the
button for a few more seconds to
start the Auto Memory function.
The frequencies are scanned from low to high.
Up to 20 FM stations with the best signal
quality are selected, sorted in order from low to
high frequency, and stored into the preset
memory. Even if you have already preset more
than 10 AM stations, you can only store up to
30 AM/FM stations total.
Note
All FM stations previously stored in memory will be replaced with
new Auto Memory stations.
1
2
3
Preset Memory
Send
On Standby
Op en/ Clos e
2
T- D Setup IPM
SW Mode Distance
T-D/ ST
A- B
Surround A.Control
-- / ---
Mode
Enter
Repeat
Muting
Up/ Down
SP Setup Test Tone CH Sel
RC- 507M
Audio
Last M Program Random
Late Night Timer
Angle
Clear
Subtitle FM Mode
Input Selector
ENTER
Light
TV
Display
VOL C H
T V In pu t Setu p
DV D Recvr Tape
Tun
Step/ Slow
To p M enu Men u
Retu rn
Clo ck Sle ep
Dimm er
1 2 3
4 5 6
+10 Search 0
7 8 9
ENTER 5/∞
Display
Hold down
«
Display
ENTER
Select the station you wish to
name.
See “Selecting preset stations” on page 37.
Press the Display button on the
remote controller for at least 2
seconds.
The DVD Receiver enters character input
mode, “NAME IN” appears on the display, then
“.....” flashes on the display.
Use the Cursor 5/∞ buttons to
select a character and press the
ENTER button to store the
character.
Flashing “.....” mark appears next to the stored
character.
Repeat step 3 to store more characters. You
can enter characters in any positon by moving
the cursor with the Cursor
2/3 button. You can
store up to 8 characters.
When 8 characters have been entered,
“COMPLETE” appears on the display. To enter
less than 8 characters, press ENTER
repeatedly to move the cursor to the end, or
hold down the Display button for more than 2
seconds.
Tip
To change an entered name, follow the steps above. In step 3, use
the Left/Right Cursor buttons
2/3 to select the name you want to
change. Change the letters of the name one at a time. To delete a
letter, select the blank space (_). You cannot delete the whole name
at once.