Janome Memory Craft 6500 - Manual (Page 72)

70
Cleaning the Hook Race and Feed Dog
WARNING:
Turn the power switch off and unplug the machine before
cleaning.
NOTE:
Do not dismantle the machine in any way other than what
is explained on this page.
1 Remove the needle and presser foot. Remove the
setscrews and remove the needle plate.
2 Take out the bobbin. Lift up the bobbin holder and
remove it.
3 Clean the bobbin holder with a lint brush and soft dry
cloth.
4 Clean the feed dog, auto thread cutter mechanism
and hook race with the lint brush.
5 Clean the hook race with a dry cloth. (You may also
use a vacuum cleaner.)
1 Screwdriver
2 Setscrew
3 Needle Plate
4 Bobbin Holder
5 Lint Brush
6 Feed Dog
7 Hook Race
8 Soft Dry Cloth
9 Auto Thread Cutter Mechanism
Assemble the hook race
1 Insert the bobbin holder. The knob of the bobbin
holder should fit next to the stopper on the hook race.
Be sure to align the red triangle marks on the bobbin
holder and stopper.
2 Reattach the needle plate and tighten the screws.
10 Knob
11 Stopper
12 Triangle Marks
NOTE:
After cleaning the machine, attach the needle and presser
foot.
1 2
2
3
4
5
4
6
5
7
9
8
11
12
10
1
2
3
4
5
1
2