Janome Memory Craft 6500 - Manual (Page 75)

73
The elongation button is pressed when a
pattern that cannot be elongated has been
selected.
Elongation is applicable only
to satin stitches.
The power is turned on again after auto
thread cutting has been interrupted.
The presser foot is raised before auto
thread cutting is completed.
Press the Thread cutter button
to finish auto thread cutting.
The machine is started when it halts due to
the overload.
The feed dog is dropped while sewing.
The bobbin winder spindle is locked while
winding a bobbin.
Wait for at least 15 seconds to
restart. Remove tangled threads
around hook race and auto thread
cutting device.
Do not drop or raise the feed dog
while the machine is running.
Turn off the power and remove
tangled threads.
The machine is out of order due to a
problem in the item indicated.
(Example: “BM init error” means error in
initialization of stepping motor.)
Contact the service center or the
store from whom the machine was
purchased.
pip Normal operation
pip-pip-pip Invalid operation or malfunction
Warning Sign Cause
Try this
Audible Signal
The LCD screen shows an
abnomal display.
Turn the power off and turn it on again.
The Buzzer Sounds when: