Janome Memory Craft 6500 - Manual (Page 74)

72
The power is turned on without the foot control
being connected.
The foot control is disconnected while sewing.
Connect the foot control and restart
the machine.
The power is turned on while depressing the foot
control.
Release the foot control.
The power is turned on with the needle in the down
position.
Press the up/down needle button
to raise the needle.
The machine is started without lowering the
presser foot.
The thread cutter button is pressed with the
presser foot raised.
The machine will stop if the presser foot is
raised while sewing.
Lower the presser foot and restart
the machine.
Lower the presser foot and press
the thread cutter button again.
The machine will stop if the buttonhole is sewn
without lowering the buttonhole lever.
Lower the buttonhole lever and
restart the machine.
The foot control is released while sewing a locking
stitch.
Depress the foot control again to
let the machine stop automatically.
The auto thread cutter button is pressed when
the machine is still initializing after turning the
power on.
Pressing the thread cutter button 4 times in a row
The twin needle button is pressed when a pattern
unsuitable for twin needle sewing has been
selected.
Sew with a single needle.
Press the thread cutter button after
the machine stops.
Problems And Warning Signals
If a buzzer sounds and the LCD screen shows a warning sign, follow the guidance below.
Warning Sign Cause Try this