JVC VR-716E - Manual (Page 105)

105
Troubleshooting
Problems Related to Error Code and Onscreen Display
Explanations
Error Code Onscreen Display Cause
E-01
1
2
E-02
E-03
2
E-04
2
E-05
1
2
E-06
1
2
E-07
1
2
E-08
1
2
E-09
1
2
—
—
1
3
—
● Consult your nearest JVC dealer.
● Continue the operation with the intact
hard disk.
● The data in the disconnected hard disk
will not be recovered if manual scan
disk is executed.
● Consult your nearest JVC dealer.
● Stop operation and check the connec-
tion.
● Double-check settings in the “REC
MODE” Menu.
✽ Recording may fail if it is continued
after the error message is displayed.
Set the “CAMERA” setting to “OFF”
in the “REC MODE” Menu or elimi-
nate the cause of the error immedi-
ately.
● This is not an error. Press the [CAN-
CEL] button to clear the message.
● Consult your nearest JVC dealer.
● If this error occurs due to alteration of
menu setting, turn the equipment off/
on and check the setting. If this error
keeps occurring due to alteration of
menu setting or during operation,
consult your nearest JVC dealer.
● Consult your nearest JVC dealer.
● Consult your nearest JVC dealer.
● This error is detected only during
Mirroring Setting.
● Consult your nearest JVC dealer.
● When hard disk space is about to run
out, make changes accordingly such as
formanting the hard disk or changing
setting to Repeat Record mode.
✽ All event record data will be deleted
when formatting is executed.
● Format the hard disk to create
recording space or set Repeat REC to
values other than “OFF”.
✽ All event record data will be deleted
when formatting is executed.
● This is not an error.
● System restarted due to error
in the functioning of hard disk.
● Error in the functioning of
hard disk.
(
✽ Unable to start up)
● No video input signals.
● Displayed when power
outage occurs.
● Error in the fan motor.
● EEPROM error.
● Encoder error.
● Decoder error.
● Error at one of the built-in
hard disk drives.
● Recordable space on the
hard disk is running out.
● No space available on the
hard disk for recording.
● Self-diagnosis of VR-716 in
progress.
Action Refer to Page
Error codes are displayed on the front display ( ☞ page 13) of VR-716.
1: Buzzer will sound when error occurs.
2: A signal will be output to [WARNING OUT] terminal when error occurs.
3: When the hard disk is full, priority is given to this display even if trigger to start recording is received such as by pressing [REC]
button or alarm input during playback. (Blinks for 5 seconds)
“E-01 DETECTED.”
—
“NO VIDEO IN** INPUT
(E-03)”
“POWER OUTAGE LOG
IS UPDATED.”
“E-05 DETECTED.”
“E-06 DETECTED.”
“E-07 DETECTED.”
“E-08 DETECTED.”
“E-09 DETECTED.”
“HARD-DISK
CAPACITY IS VERY
LITTLE”
“NO HARD-DISK
REMAINING
CAPACITY”
“MAINTENANCE
PROCEEDING”
—
—
P14
P71
—
—
—
—
—
P58
P25
P58
P25
—