JVC VR-716E - Manual (Page 106)

106
Troubleshooting (continued)
Other Problems
Explanations (continued)
Symptom Cause
● Plug the supplied power cable to the outlet.
● Turn off the Operation Lock
● Press the [TIMER] button to turn off the timer
program.
● Connect the monitor properly.
● Select a camera with recorded images.
● Check the date/time setting.
● Press the [TIMER] button to set to the Program
Timer Standby mode.
● Double-check the record program of the
Program Timer.
● Press the [TIMER] button to turn off the timer
program.
● Turn off the Operation Lock
● Set items in the “ONSCREEN MODE” Menu to
“ON” accordingly to enable them to be displayed
onscreen.
● Set the date/time.
● Double-check the record program of the
Program Timer.
● Format the hard disk to create recording space
or set Repeat REC to values other than “OFF”.
● Execute recording with the “AUDIO REC” item in
the “REC MODE” menu set to “ON”.
Audio recording is disabled when recording is
executed with the “FRAME RATE” in the “REC
MODE” Menu set to “1/6 IPS” (1 image per 6
seconds) or “1/12 IPS” (1 image per 12 sec-
onds).
● Set the date/time.
● Perform the Jump setting accordingly.
● Disconnect and connect the power cord.
● Is the power cable properly
connected?
● Is the Operation Lock turned on?
● Is the [TIMER] indicator on?
● Is the monitor properly connected?
● Are there recorded images on the
camera selected using the ‘Camera
Selection’ buttons?
● Is the date/time set?
● Is the [TIMER] indicator on?
● Is the timer program properly set?
● Is the [TIMER] indicator on?
● Is the Operation Lock turned on?
● Are the items set to “OFF” in the
“ONSCREEN MODE” Menu?
● Is the date/time properly set?
● Either the Program Timer is not
programmed, or there is no record
program that can be executed.
● Is there sufficient hard disk space?
● Was the “AUDIO REC” item in the
“REC MODE” menu set to “ON”
during recording?
● Is the date/time properly set?
● Is the Jump setting correct?
● System error occurred.
Action Refer to Page
Power cannot be turned
on.
[REC] and [PLAY]
buttons do not work.
Playback image is not
displayed on the
monitor.
Unable to start program
recording using the
Program Timer
Menu screen is not
displayed.
No onscreen display of
date/time and title.
Date/Time is not
recorded.
[TIMER] indicator
blinks.
Unable to play back
audio sound.
Unable to execute Skip
Jump or Direct Jump
All the LEDs of camera
light up in red.
—
P5
P8, P12, P54
P14, P15
P32, P33
P18
P46~P54
P8, P12, P54
P5
P19
P18
P46~P54
P58
P24
P18
P40~P43
—