JVC VR-716E - Manual (Page 18)

18
STILL
DISPLAY
CANCEL SEARCH MENU
REV
SKIP
FWD
HDD OPERAT
LOCK
VIDEO AU
OUT EXECUTE
TIMER
2.3.4.6. 1.7. 3.4.5.6.
DISPLAY
REV FWD
REV FWD
REV FWD
DISPLAY
Installation and Preparation (continued)
Setting the Date/Time
Setting Using the Front Display
Set the date/time on the front display of VR-716. 1.
Press the [DISPLAY] button for 2 seconds or
longer
• The “D” (Day) item on the front display will start to blink.
2.
Turn the jog dial to adjust “D” (Day)
3.
Press [ ] to move the blinking cursor to “M”
and turn the jog dial to adjust the month
4.
Press [ ] to move the blinking cursor to “Y” and
turn the jog dial to adjust the year
5.
Press the [ ] button
• The hour and minute values will be displayed on the front display but
only the hour value blinks.
6.
Adjust “H” (Hour) and “M” (Minute)
• Repeat Steps 3 ~ 4 to adjust the hour and minute values.
7.
Press the [DISPLAY] button
• This sets and starts the clock.
• Pay attention when changing dates if the
hard disk contains recorded data.
Playback, Skip Jump or Direct Jump by
Date/Time may not properly function if there
is overlap in the recording dates.
• The “TIME ZONE” item cannot be altered
on the front display.
• Refer to the notes related to Summer Time.
(
☞ Page 116)
Caution
• Date/Time setting is disabled when VR-716 is in the Recording mode.
When adjusting the seconds:
• Press and hold the [LOCK] button followed
by pressing the [STOP] button to adjust the
seconds of the clock.
• When the value is 29 seconds or less, this
will be reset to 00 seconds with the minute
value unchanged.
• When the value is 30 seconds and above,
this will be reset to 00 seconds with the
minute rounded to the next higher value.
• The order of D/M/Y will change in accor-
dance with the “DATE DISPLAY” setting in
the “ONSCREEN MODE” menu.
Note
Notes
• Ensure to set the TIME ZONE before set-
ting the Date/ Time.
Caution