JVC VR-716E - Manual (Page 97)

97
1.
Click z
• Mail notification may fail depending on the
authentication method at the mail server.
• Consult your network administrator on the
mail server’s settings.
• A complete alarm/sensor list may not be
received depending on the maximum no.
of characters a mobile can receive.
• Regardless of the interval setting of mail
notification, the mail notification will be sent
within 10 minutes from the first alarm/sen-
sor input. It may take much time before
data can be received depending on the
network environment.
Caution
Mail Notification Setting During Alarm/Sensor Input
In a network environment where use of a mail server (SMTP) is possible, mail notification setting can be performed at VR-716 to
send out the alarm list during alarm/sensor input in the form of notification messages on a regular basis.
Select a [Mode].
Notes
Register the [Mail (SMTP)
Server ].
Select an [Interval] for
sending out notification
messages (5, 10, 15 or
30 minutes).
Register the mail
address of the [To E-
MAIL].
Register the mail
address of the [From
E-MAIL].
Click [SAVE].
Ⅵ Upon setting, the mail notification feature can be
checked to ensure that it is properly functioning.
• Clicking [SAVE] at the [E-MAIL SETUP] screen displays a confirmation
screen.
• Click [TEST E-MAIL] to issue a test mail. Check that this mail is received
at the specified destination.
• When sending of notification fails due to errors in the settings or network,
an error message will be displayed. Check the mail notification as well as
network settings.
<Selection items for 1>
• [None]:
Disables the mail notification feature.
• [Alarm/Sensor]:
Sends out mail notification during alarm/
sensor input.
• When using the mail notification feature,
perform settings described in page 96 ‘Net-
work Settings’ as well.
• To use the mail notification feature, the
following information must be registered.
• Mode
• Mail (SMTP) Server
(Enter the domain name.)
• Sender’s Mail Address
• Minimum Mail Notification Interval
• Receiver’s Mail Address
• Notification mails can be sent out to mul-
tiple receivers by inserting [ , ] or a space
between the receivers’ mail addresses.
(Maximum no. of input characters is 254)
• The following is registered as the [Subject:]
in the factory settings:
[Starting Alarm/Sensor REC!!]
(Maximum no. of input characters is 32)
• [Normal] or [Short] can also be selected
from the [List Form] as the mode of mes-
sage display.
Click [TEST E-MAIL].
1
2
3
4
5
6
1