JVC LET0239-001A - Manual (Page 19)

19
7
Check what happened on the satellite
receiver.
If the satellite receiver’s programme position number
has not changed correctly...
Press 5 or ∞ to move to “NOT CHANGED,” then
press ENTER or 3 . Then perform the procedure again
from step 5 .
• Interference from the signals sent from the remote
control in step 6 may be considered as one of the
causes for the unsatisfactory result. In this case, take an
preventative method to avoid that interference.
NOTES
•For some satellite receivers, it is required to select 2-digit input
for the programme position number entry.
•If your satellite receiver has more than two channel modes, be
sure to set to “All Channel Mode.” For details, refer to the
instruction manual of the satellite receiver.
•The satellite controller may not be used with some types of the
satellite receivers. If this is your case, leave the satellite tuner
turned on and select an appropriate programme position
number on the satellite receiver before the scheduled start time
for a timer recording comes.
You can also use the timer equipped with your satellite
receiver.
If the satellite receiver’s
programme position number
has changed to the same one
as you set in step
6 ...
Press 5 or ∞ to move to
“CHANGED TO...,” then
press
ENTER or 3 to finish
the setting. [ENTER]
[SET UP]
Brand name Code
JVC
AMSTRAD
CANAL SATELLITE
CANAL +
D-BOX
ECHOSTAR (VIA DIGITAL)
FINLUX
FORCE
GALAXIS
GRUNDIG
HIRSCHMANN
HUMAX
ITT NOKIA
KATHREIN
LUXOR
MASCOM
MASPRO
NOKIA
PACE
PANASONIC
PHILIPS
RADIX
RFT
SABA
SAGEM
SALORA
SAMSUNG
SIEMENS
SKYMASTER
TECHNISAT
THOMSON
TPS
TRIAX
WISI 73
60, 61, 62, 63, 92
81
81
85
82
68
89
88
64, 65, 102
64, 78, 99
88
68
70, 71, 96
68
93
70
87, 94
65, 67, 74, 86, 92
74, 92
66, 84, 101
78
69
97
83, 90
68
83
64
69, 98
66, 100
97
83
91
64