JVC LET0239-001A - Manual (Page 85)

85
To use the HDD deck for the recording component:
1
Make connections
Connect the VCR through the L-2 IN (or L-1 IN/OUT)
connector on the rear using the 21-pin SCART cable (not
supplied).
• When using the L-2 IN connector, set “L-2 SELECT” to
“A/V” (see page 68).
• If both the external VCR and the TV are compatible
with S-Video signal:
Set “L-1 OUTPUT” or “L-2 INPUT” to “S-VIDEO” (see
page 68).
2
Select the HDD deck.
On the remote control
Set the DVD/TV/HDD selector set to the right ( HDD ),
then press ENTER (or LIVE ).
On the unit
Press DVD/HDD so that the HDD lamp lights.
3
Select the input mode on the HDD deck.
On the remote control
Press AUX ( number button “ 0 ”) and/or HDD/TV PR +/–
to select “L-2” for the L-2 IN connection, or “L-1” for the
L-1 IN/OUT connection.
On the unit
Press PR +/– to select “L-2” for the L-2 IN connection, or
“L-1” for the L-1 IN/OUT connection.
NOTE
When connecting a TV with TV-Link or with equivalent function
(see page 15) using the SCART cable, select “OFF” for “DIRECT
REC” (see page 67) in order to record S-Video signals through
the L-2 IN connector.
4
Start playback on the VCR.
• Refer to the instruction manual supplied with the VCR.
5
Start recording on the HDD deck.
On the remote control
Press and hold REC ¶ , then press 3 .
On the unit
Press ¶ (record).
The lamp next to the ¶ (record) button lights.
NOTE
For Y/C signal input/output, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.
Precaution before editing onto the HDD
The picture shown on the TV is a few seconds
behind the scene currently recorded onto the HDD.
Therefore, if you start recording at the desired scene
on the TV, you will miss the beginning of the scene by
a few seconds. On the other hand, when you stop
recording, you will record some extra scenes.
ANTENNA
L-1
VIDEO SIGNAL SELECTOR VIDEO OUT AUDIO OUT
L-2
OUT
IN/OUT DVD DVD/HDD
SAT CONTROL
AV COMPU LINK
IN
OPTICAL COAXIAL
DVD DIGITAL OUT
PCM / STREAM LEFT
RIGHT
IN Y / C COMP. / RGB
S-VIDEO
VIDEO
21-pin SCART
cables (not supplied)
XV-DDV1SL TV
VCR
ANTENNA
L-1
VIDEO SIGNAL SELECTOR VIDEO OUT AUDIO OUT
L-2
OUT
IN/OUT DVD DVD/HDD
SAT CONTROL
AV COMPU LINK
IN
OPTICAL COAXIAL
DVD DIGITAL OUT
PCM / STREAM LEFT
RIGHT
IN Y / C COMP. / RGB
S-VIDEO
VIDEO
Connection to the L-2 IN connector with the SCART
cables
When connecting the VCR to the L-1 IN/OUT
connector:
VCR
TV XV-DDV1SL
S-video cable
(not supplied)
21-pin SCART
cables (not supplied)
S-Video cable connection is required only when the VCR is
not compatible with S-Video, but the TV is compatible.
The HDD deck is not compatible with RGB signal input. So
do not connect an RGB component to the L-2 IN connector
(or do not set the signal output mode of the connected
component to RGB signal).