Timer recording, Video plus+ timer programing, Video p – JVC LET0239-001A User Manual
Page 40: Timer programming, 1 7 2 – p 3
40
TIMER RECORDING
This unit allows you to preset up to 16 recording timer
settings using either one of the following:
• VIDEO P
LUS
+
®
Timer programming
• Express Timer programming
VIDEO P
LUS
+
®
Timer
programming
With the VIDEO P
LUS
+
®
system, timer programming is
greatly simplified because each TV programme has a
respective code number which this unit is able to
recognize.
To go back to the previous screen while programming,
press
RETURN
.
1
Show the PROGRAM screen.
2
Select the VIDEO P
LUS
+
®
Timer programming.
Press
3
/
2
/
∞
/
5
to move to “VIDEO PLUS+,” then
press
ENTER
.
NOTE
If “PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME” appears on the TV, erase unwanted
programmings from memory (see page 45).
3
Enter the P
LUS
C
ODE
number.
NOTE
You can also use
number
buttons to enter the
P
LUS
C
ODE
number
.
•
To make an incorrect number,
press
3
/
2
/
∞
/
5
to
move to “DELETE,” then press
ENTER
.
Each time you press the button, the last entry is
cancelled.
•
To delete all entered numbers at a time,
press
3
/
2
/
∞
/
5
to move to “DELETE ALL,” then press
ENTER
.
4
Confirm the P
LUS
C
ODE
number.
NOTES
•If the number you entered is invalid, “PLUSCODE NO. ERROR
CONFIRM PLUSCODE NO. THEN RETRY” appears on the TV.
Enter a valid P
LUS
C
ODE
number.
•If “...SET GUIDE PROG THEN RETRY” appears on the TV, set
Guide Program numbers (see page 69) manually.
• Make sure that the clock built in this unit is set
properly.
• Turn on the TV and select an appropriate input (AV)
mode.
• To record a satellite broadcast, install the supplied
satellite controller on page 17.
• When using the buttons on the unit, make sure that
the HDD lamp on the unit is lit. If not, press
DVD/
HDD
so that the HDD lamp lights.
• When using the remote control, slide the
DVD/TV/
HDD
selector to the right (
HDD
), then press
ENTER
.
1
2 p
–
1
7
2
–
p
3
Press
HDD PROGRAMME
.
1
Press
3
/
2
/
∞
/
5
to
move to a desired
number, then press
ENTER
.
2
Repeat step
1
until you
enter the entire
P
LUS
C
ODE
number.
Press
∞
to move to
“CONFIRM,” then press
ENTER
.
• The P
LUS
C
ODE
number you
have entered and its
contents of the timer
programming are shown
on the screen.