JVC LET0239-001A - Manual (Page 42)

42
TIMER RECORDING (cont.)
Express Timer programming
If you do not know the P LUS C ODE number for a TV
programme you want to record, use the following
procedure to set the timer programmings.
To go back to the previous screen while programming,
press RETURN .
1
Show the PROGRAM screen.
2
Select the Express Timer programming.
1 Make sure that is pointing at “PROGRAMME.”
2 Press ENTER.
NOTE
If “PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME” appears on the TV, erase unwanted
programmings from memory (see page 45).
3
Set the date.
Press 3 / 2 / ∞ / 5 to move to the desired date, then
press ENTER .
4
Set the start time and stop time of the
programme.
1 Press ∞ or 5 to move to “START,” then press
ENTER .
2 Press ∞ or 5 to select the desired time, then press
ENTER .
3 Press ∞ or 5 to move to “STOP,” then press
ENTER .
4 Press ∞ or 5 to select the desired time, then press
ENTER .
5
Select the programme position number.
1 Press ∞ or 5 to move to “TV PROG,” then press
ENTER .
• If you want to timer-record a satellite broadcast,
press the number button “ 0 ” to change “TV PROG”
to “SAT” before pressing ENTER .
2 Press ∞ or 5 to select the desired programme
position number, then press ENTER .
3 Press ∞ to move the cursor to “CONFIRM,” then
press ENTER .
6
Select the recording speed.
1 Press ∞ or 5 to move to “REC MODE,” then press
ENTER.
2 Press ∞ or 5 to select the desire mode, then press
ENTER.
• Make sure that the clock built in this unit is set
properly.
• Turn on the TV and select an appropriate input (AV)
mode.
• When using the buttons on the unit, make sure that
the HDD lamp on the unit is lit. If not, press DVD/
HDD so that the HDD lamp lights.
• When using the remote control, slide the DVD/TV/
HDD selector to the right (HDD), then press ENTER.
1 2 p –
1
2
– p
5
7
Press HDD PROGRAMME.