Symbol Technologies SPT 1500 - Manual (Page 49)

2-19
Working with your SPT 1500
To use the Graffiti menu commands, draw the Command stroke followed by the
corresponding command letter. When you draw the Command stroke, the Command symbol
appears just above the Graffiti writing area to indicate that you are in Command mode.
For example, to activate the Select All command in the previous diagram, draw the
Command stroke, followed by the letter “s.”
Note: You do not have to tap the icon or access the menus when you use
the Graffiti menu commands. However, since the Command mode is
active for approximately two seconds, you must write the letter
character immediately to activate the menu command.
Edit Menu Commands
The Edit menu is available with any screen where you enter or edit text. In general, the Edit
Menu commands available in the Edit menu apply to text that you select in an application.
To select text in an application:
1. Tap the beginning of the text that you want to select.
2. Drag the stylus over the text to highlight it (in black).
Note: You can drag across the text to select additional words, or drag down
to select a group of lines.
The following commands may appear in an Edit menu:
Command
Command letters
Menu commands