SATO CT410 - Manual (Page 139)

OPTIONAL RS232C SERIAL INTERFACE
The High Speed Serial Interface is an factory installed option that must be installed in
the printer at the time of order. It is activated by placing DSW-8 on the Configuration
Panel in the OFF position.
GENERAL SPECIFICATIONS
Asynchronous ASCII Half-duplex communication
Ready/Busy Hardware Flow Control
Pin 20, DTR Control
Pin 4, RTS Error Condition
X-On/X-Off Software Flow Control
Bi-Directional Communication
Data Transmission Rate 9600, 19200, 38400, 57600 bps
Character Format 1 Start Bit (fixed)
7 or 8 data bits (selectable)
Odd, Even or No Parity (selectable)
1 or 2 Stop bits (selectable)
ELECTRICAL SPECIFICATIONS
Connector DB-25S (Female)
Cable DB-25P (Male), 50 ft. maximum length. For cable
configuration, refer to Cable Requirements appropriate
to the RS232C protocol chosen.
Signal Levels High = +5V to +12V
Low = -5V to -12V
PIN ASSIGNMENTS
Pin 1 Pin 13
Pin 25
Pin 14
Section 5. Interface Specifications
SATO CT Series Printers 900106 9A Page 5-5