SATO CT410 - Manual (Page 26)

LABEL SENSING
The CT Series printers can use either label Gap (see-thru) or Eye-Mark (reflective)
sensing. The Sensor Assembly is located on the left edge of the media and is
automatically positioned by the Paper Guides.
The printer is shipped from the factory with the default sensing method set for label
gap. The setting can be overridden by using the <ESC>IG command (Section 4)
however it will be reset to the default when power is cycled. The default setting can
be changed using the <ESC>PG command (Section 4) or the Printer Configuration
Utility program on the CD-ROM.
Eye-Mark
Roll Paper
Eye-Mark
Fanfold Paper
0.20" (5 mm) Eye-Mark Sensor
0.25" (6.3 mm) Gap Sensor
Inter-Label Gap
Min. 0.12" (3 mm)
Max. 0.20" (5 mm)
Backing
Paper Inside
Edge
Label Inside Edge
Label
Feed
Direction
Miminum Eye-Mark Size
.12 in (3 mm) W x .5 in. (12 mm) L
CT Series Printer Label Sensor Positioning
Section 2. Installation and Configuration
Page 2-10 9001069 A SATO CT Series Printers