SATO CT410 - Manual (Page 71)

Clear Print Job(s) & Memory
Command Structure <ESC>*a
a = If the “a” parameter is not included with this command and
the printer is in the multi-buffer mode, this command clears
all print jobs in the printer memory, including the current
print job.
a = If “a” is included with this command, it specifies the internal
memory section to be cleared
T
To clear the custom character memory
& To clear the form overlay memory
X To clear all internal memory
Example: <ESC>*
<ESC>*X
Placement: This command should be sent to the printer as an
independent data stream.
Default: None
Command Function To clear individual memory or buffer areas of the printer.
Input to Printer <ESC>A
<ESC>*
<ESC>Z
Printer Output There is no printer output as a result of this command. The current
print job in the buffer will be terminated and all other print jobs in the
buffer cleared.
Special Note 1. It is not necessary to clear the printer’s memory between each print
job.
2. The primary purpose of this command is to clear all print jobs in the
multi-buffer mode. The “a” parameter can be used in either the
multi-buffer or single job mode to clear specific parts of the
memory.
3. When the “a” parameter is used, the section of memory specified
will not be cleared until the label is printed.
Section 4. Programming Reference
SATO CT Series Printers 9001069 A Page 4-27