SATO CT410 - Manual (Page 62)

Special Notes 1. Use of this command will set the Vertical/Horizontal Offset setting of
the printer configuration until a new Base Reference Point
command is issued or the setting is changed from the operator
panel. See Section 2: Printer Configuration.
2. This command may be used more than once in a print job.
3. An alternative to using this command is to make changes to your
current Horizontal and Vertical Print Position commands.
Example:
Let’s say the current base reference point is H=1, V=1 and you
wish to move all the fields on your label downward vertically by
150 dots. You could either (1) add the Base Reference Point
command or (2) change all the vertical position commands by an
additional 150 dots.
4. For a more detailed example of the Base Reference Point
command, see “Print Area” in this section.
5. The allowable field ranges for this command are:
CT400 CT410
Horizontal
aaaa
-0832 to 0832 -1248 to 1248
Vertical
bbbb
-3200 to 3200 -4800 to 4800
Section 4. Programming Reference
Page 4-18 9001069 A SATO CT Series Printers