SATO CT410 - Manual (Page 76)

Cut
Command Structure <ESC>CTaaaa
aaaa = Number of labels to print between each cut (1-9999)
Example: <ESC>CT2
Placement: Preceding the <ESC>Q Print Quantity command.
Default: <ESC>CT1 (if cutter enabled)
Command Function To control the cutting of labels when using a SATO cutter unit with
the printer printer. This command allows the cutting of a multi-part tag
or label at a specified interval within a print job. It differs from the
<ESC>~ Cut Job command in that it does not interact with the
quantity command.
Input to Printer: <ESC>A
<ESC>H0020<ESC>V0020<ESC>XB1ABC<ESC>CT0002
<ESC>Q7<ESC>Z
Printer Output: This set of commands will print seven labels with two labels between
each cut. One label will be left in the printer.
Special Notes 1. You must have the optional printer Cutter to use this function.
Contact your SATO representative for more information.
2. To use this command, the printer configuration must have the cutter
option enabled. See Configuration Commands in this section of
the manual.
3. If the cutter option has been enabled in the printer configuration
and the cut value (a = 0), the cutter is inactive.
4. This command is independent of the <ESC>Q Quantity command.
It will cut the specified number of labels. If a printed label is left in
the printer after the last cut, the <ESC>YC Cut/Eject command
can be used to cut it.
ABC ABC ABC ABC ABC ABC ABC
7pc
2pc
Left on printer Cut Cut Cut
Section 4. Programming Reference
Page 4-32 9001069 A SATO CT Series Printers