SATO CT410 - Manual (Page 97)

4. This command is invalid only if the value specified is zero.
5. Following this command with a <CR> character will allow you to
print with auto line feed. In this case, the print position will be
determined from the value specified in the command and the H
value set in the printer. However, if you specify several H values
after this command, the print position will be determined by the H
value last specified. You must redefine the font to be used after
each H command.
Section 4. Programming Reference
SATO CT Series Printers 9001069 A Page 4-53