Smooth Fitness SMOOTH CE-3.0DS - Manual (Page 34)

33
“
C
ONSOLE
T
ROUBLE
S
HOOTING
G
UIDE
“
PROBLEM POSSIBLE CAUSE SOLUTION
The Speed
Display Show
“O”
The Computer isn’t receiving a
signal from the Speed
Sensor?
Verify the gap between Speed Sensor and the Magnet is 5mm or less
Verify that all the Wire Plugs are connected FIRMLY, correctly and are not
damaged
Verify that the sensor Magnet is installed correctly
The Sensor is faulty Replace the Speed Sensor
The Computer is faulty Replace the Computer
The LCD
Screen
Partially
Displays
1. The connection between
the Circuit Board and the
LCD Membrane is loose.
2. Gently press down on the
LCD Screen, if the partial
display disappears, then it
is a connection problem
Verify that the Circuit Board is securely fastened to the Computer Case.
Retighten the Screws. Take care NOT to over tighten the Screws as this may
destroy the Circuit Board. You just need to keep the Circuit Board firm, STOP
tightening screw when you meet resistance
The Rubber Membranes
between the Circuit Board and
the LCD Screen is
misaligned/not in a same line.
You might be able to see that
the LCD Screen is on a slight
angle and NOT inline or
parallel with the Console
Cover
1. Open the Console.
2. Remove the Circuit Board ’s Screws, gently remove the Circuit Board,
Re-align the LCD screen and the Rubber Membrane.
3. Reassemble the Circuit Board and taking care not to bump or knock the
Rubber Membrane out of alignment before the Circuit Board Screws are
tight. You just need to keep the Circuit Board firm, STOP tightening
screws when you meet resistance
The Computer is faulty
Replace the Computer
Recalibrate tension motor
reset Odometer Press and hold up, down, mode, and enter the motor will recalibrate and the
odomerter will reset to 0