Sharp AR-C160 - Manual (Page 107)

5-13
CHAPTER
5
TROUBLESHOOTING
Always check the message display whenever the copier stops or
operation is not possible. The messages will give you easy-to-follow
directions. If the messages do not give specific instructions, check the
list below.
COPIER TROUBLE?
Troubleshooting
Copier does not operate.
Copies are too dark or too
light.
Blank copies.
Copies smear if rubbed.
● Copier plugged in?
● Power switch on?
● Copy density properly adjusted?
● Is the original placed face down on
the document glass or face up in
the optional RADF?
● Paper too heavy?
● Paper damp?
● Paper size indicator properly set?
Plug the copier into a grounded outlet.
Turn the power switch on.
See page 2-16.
Place the original face down on the
document glass or face up in the RADF.
Use copy paper within the specified
range. See page 4-2.
Replace with dry copy paper. Be sure
to store copy paper in a dry location.
When changing the copy paper size in
a tray, be sure to adjust the paper size
indicator. See page 4-4.
Problem Solution
Copy size is different from
the selected paper size.