Sharp AR-C160 - Manual (Page 43)

2-19
CHAPTER
2
MAKING COPIES
Job memory
Deleting a stored job program
1 Follow steps 1 and 2 in “Storing a job program” on the
previous page. (1. Press the PROGRAM key. 2. Press
the “STORE/DELETE” key.)
2 Select the storage register number of the program to be
deleted.
● Be sure to select a number which contains a stored program. If
not, “Storing a job program” operation will start.
3 Press the “DELETE” key or the “CANCEL” key.
● If the “DELETE” key is pressed, the program will be deleted from
memory.
● Press the “CANCEL” key to keep the program.
4 Press the “EXIT” key to exit the job memory mode.
Recalling a job program
1 Press the PROGRAM key.
● The JOB PROGRAMS screen will appear on the touch panel.
● The numbers which are highlighted are program numbers which
contain stored programs.
2 Select a stored program from 1 to 9 on the touch panel.
● All selections stored in the program will appear on the touch
panel.
● The recalled settings may be modified for a particular job run, but
any changes made will not be stored in the job memory. To store
the new settings, follow the “Storing a job program” procedure.
JOB MEMORY
JOB PROGRAMS
STORE/DELETE RECALL
PRESS PROGRAM NUMBER.
EXIT
JOB PROGRAMS
JOB PROGRAM HAS BEEN ALREADY STORED.
STORE ANOTHER PROGRAM?
OR DELETE?
CANCEL DELETE STORE
STORE/DELETE RECALL
PRESS PROGRAM NUMBER.
JOB PROGRAMS
STORE/DELETE RECALL
PRESS PROGRAM NUMBER.
EXIT
JOB PROGRAMS
STORE/DELETE RECALL
PRESS PROGRAM NUMBER.
EXIT
8 9
0 P
C
CLEAR
PROGRAM IT