Sharp AR-C160 - Manual (Page 44)

2-20
CHAPTER
2
1 Press the INTERRUPT key.
● When the optional document feeder is being used, the copier will
stop after copying any originals which have been fed into the
document feeder. The INTERRUPT indicator will blink until the
copier stops.
When the copier stops, it will return to its initial settings and the
INTERRUPT indicator will light steadily. At this time, the copier
is ready for interrupt copying.
● If the copier has been programmed in the auditing mode, the
account number entry message will appear. Enter your account
number using the 10-key pad. The number of copies of the
interrupt copying will be accumulated against this account
number.
2 When the copier stops, remove the original(s) and set
the original(s) for interrupt copying on the document
glass or in the optional document feeder tray.
3 Select the desired available copier functions.
4 Press the COLOR COPY START ( ) key or BLACK
COPY START ( ) key.
5 When the interrupt copy run is complete, press the
INTERRUPT key again to cancel the mode and remove
the original(s) used for interrupt copying.
● The copier will reset itself to the functions which were in use
before the INTERRUPT key was first pressed.
6 Replace the original(s) for the interrupted job and press
the COLOR COPY START (
) key or BLACK COPY
START ( ) key to resume copying.
MAKING COPIES
Interrupting a copy run
INTERRUPTING A COPY RUN
INTERRUPT can be used to temporarily stop a long copy run so that
another job can be run.
● INTERRUPT will not function during duplex copying (when an
optional duplex module (AR-DU2N) is installed).
● Duplex copying, sort, group, staple sort and offset cannot be
selected during interrupt copying. Also job program recall cannot be
selected.
3
6
CA
INTERRUPT
CLEAR
ALL
3
6
CA
INTERRUPT
CLEAR
ALL
3
6
9
P
C
CA
CLEAR
PROGRAM
INTERRUPT
CLEAR
ALL