Siemens 4110 - Manual (Page 88)

87
Appendix
Gigaset 4110isdn, GBR, A31008-G4110-B102-2-7619 Anhang.fm 4.9.02
Appendix
Maintenance
Simply wipe the base station and handset with a damp cloth or an antistatic
wipe. Never use a dry cloth as this can cause static discharge.
Contact with liquid
If the handset should come into contact with liquid,
on no account switch the device on.
Remove all batteries immediately.
Allow the liquid to drip out of the device, and then dab all parts of the device
dry.
Keep the handset with the batteries removed in a warm, dray place for at least
72 hours. In many cases, you will then be able to use it again.
Questions and answers
If any questions occur to you while you are using your device, we are available
24 hours a day at www.my-siemens.com/customercare. You will find the
most frequently asked questions and answers below.
Question Possible cause Possible solution
The handset does not
ring after the ISDN call
number (MSN) has been
set up. The local area code was
saved with the MSN. Save the MSN without
the local area code
(page 27)
The handset does not
ring. Ring tone has been
deactivated.
Night service active
Press activate ring
tone
~
.
Deactivate night serv-
ice (page 66)
There is no display. The handset is not
switched on. Press the replace
handset key
for 1 second.
The batteries need
charging. Charge or replace
the batteries
(page 14).
Nothing happens when I
press the keys. The keypad lock is
activated. Press
*
for
1 second.
There’s no radio link to
the base –
ORRNLQJ
IRU EDVH flashes, for
example.
The handset is outside
the range of the base. Move the handset and
base closer together.
The handset has not
been registered. Register the handset
(page 18).
The base is not
switched on. Check the plug-in power
supply on the base
(page 12).
!