SRS Labs Projector 8953H - Manual (Page 29)

29
3. Using the Live Mode
3.3 Quick connection to the network (continued)
• If the DHCP is set on in the projector, the network connection
between the projector and PC may not be established since IP address may be
varied. If you like to use the My Connection, set the DHCP off in the projector.
• If no profile data is assigned to the My Connection, it can’t be used.
NOTE
Proceed to the item 3.6 Confirm the connection to your destination. (50)
[trouble shooting]
Select [My Connection] and click [Connect].
If you select the My Connection, the PC
is connected to the projector through the
network by using the profile data that is pre-
assigned to My Connection. (62)
When you select the My Connection, the
PC immediately starts the connection to the
projector.
Selecting the My Connection
n A network connection could not be established.
Windows prevented network configuration
changes.
You may log in the Windows under User
authority.
Click [OK] to return to the screen to select
the network connection mode. (27)
Consult to the network administrator and log in again under the Administrator
authority. After that, please resume at the item 3.3.1 Starting the “Live Viewer
3”. (26)