Sierra Wireless RAVEN 20070914 - Manual (Page 107)

Raven 1x
102 20070914
Figure 1-4: AceManager : Serial
En
Toggle AT command echo mode.
• n=0 : Echo Off.
• n=1 : Echo On.
Qn
The AT quiet‐mode setting. If quiet mode is set, there will be
no responses to AT commands except for data queried.
• n=0 : Off (Default).
• n=1 : Quiet‐mode on.
S3=n
The standard end of line character used to indicate the end of
an AT command. This character is also used as the carriage
return character for framing responses and result codes in
command state. Cannot be configured in AceManager.
• n=0‐127 (ASCII character number)
S4=n
The standard line feed character sent by the modem to the host
at the end of a response or return code in command state.
Cannot be configured in AceManager.
• n=0‐127 (ASCII character number)
S5=n
This register sets the character recognized as a backspace
during command entry. Cannot be configured in AceManager.
• n=0‐127 (ASCII character number)