Sierra Wireless RAVEN 20070914 - Manual (Page 30)

Activating your Raven on the TELUS Network
Rev 3.0B Feb.08 25
Figure 3-8: Setup Wizard : Signal Test
Tip:
6. Test Modem Setup
Your connection of your Raven to the Internet is tested using
the TELUS cellular network.
Figure 3-9: Setup Wizard: Connection Test
Green checks in the boxes indicate the tests were successful
and your Raven is functioning properly. At this point your
modem is configured and activated to work on the TELUS
network.
Note: These tests, depending on the strength of your signal, may take
a few minutes. Initially, while the tests are being performed, there may
be red
X s in the boxes. The Status line will give an indication of the
progress of the connection process.
If Test Modem Settings shows the status of your modem is
“Data Connection Failed ‐ Waiting for Retry”, “No Service”,
“No Carrier”, “Network Negotiation Failed”, “Network
Authentication Failed”, “Modem Not Registered”, or the Reg
Net light on the modem is not lit, double‐check your device
activation information and return to the Activate Modem step
to reconfigure your Raven.