Sierra Wireless RAVEN 20070914 - Manual (Page 33)

Raven 1x
28 20070914
Figure 3-14: Setup Wizard : DUN
At the completion of the DUN installation, you will return to
the Dial‐up Networking Connection screen. The AirLink
modem should now be listed as a connection.
Your modem is now ready to be used as a DUN device for any
applications on your computer needing a network connection.
If you have DUN installed for more than one modem, you will
need to specify in your application which DUN to use. Unless
it is the only DUN, your Raven may not be the one your
computer sees as a default.
Activating Using AT Commands
An alternate method to configure and activate your Raven is
by using AT commands sent directly to the modem with a
terminal application (refer to the troubleshooting section). This
method is recommended only in situations where the Setup
Wizard is not available and/or when the configuration for the
Raven is unusual.
Caution: It is not possible to activate the Raven using either
AceManager or AceNet.
1. Set telnet timeout in to 20 minutes.
AT*TELNETTIMEOUT=20
2. Save the telnet setting.
AT&W
3. Verify ALEOS has established communication to the
internal hardware.
ATI3
4. Enter the activation command appropriate for your type of
account. The SID and NID are optional and only required
if your account type uses them.
· If you have the same number for the MIN and MDN or
MSID:
AT*PROVISION=MSL,MDN[,SID,NID]