Sierra Wireless RAVEN 20070914 - Manual (Page 115)

Raven 1x
110 20070914
S83=n
Set or query UDP auto answer idle time‐out. If no data is sent
or received before the time‐out occurs, the current UDP session
will be terminated. While a session is active, packets from
other IP addresses will be discarded (unless *UALL is set).
• n=0 : No idle time‐out (Default).
• n=1 ‐ 255 : Time‐out in seconds.
*DU=n
The dial command always uses UDP, even when using ATDT.
• n=0 : Dial using the means specified (default).
• n=1 : Dial UDP always, even when using ATDT.
Note: When this parameter is set you cannot establish a TCP PAD
connection.
*UALL=n
Accepts UDP packets from any IP address when a UDP
session is active. If there is no UDP session active, an incoming
UDP packet will be treated according to the UDP auto answer
and AIP settings.
• n=0 : No effect (Default).
• n=1 : Accept UDP data from all IP addresses when in a
UDP session.
*UDPLAST=n
Note: *UDPLAST does not
change the S53 setting in
NVRAM. If the modem is reset,
the original S53 setting will be
restored from NVRAM. If enabled, sets S53 to the last accepted IP address through
UDP auto answer. This can be used in conjunction with MD3
so that when there is no UDP session, new ethernet host data
will cause a connection to be restored to the last IP accepted
through UDP auto answer.
• n=0 : Does not change S53 setting. (Default).
• n=1 : Set S53 to the last accepted IP.
*USD=n
Waits the specified delay before sending the first UDP packet
and the subsequent UDP packets out to the port Ethernet.
• n=0 : No UDP packet delay (Default).
• n=1 ‐ 255 : Delay in 100ms units, from 100 ms to 25.5 sec.