Sierra Wireless RAVEN 20070914 - Manual (Page 139)

Raven 1x
134 20070914
Figure 2-1: AceManager : UDP > MD
The Raven needs a command string sent to the modem after it
is initialized. The command string will need to be tailored for
your application. Different models of the Raven may respond
differently to some of the commands. In the PassThru group,
type your command string in the input field for *PTINIT.
Figure 2-2: AceManager: PassThru
AT Commands and the Command String
Each modem requires a command string that is a combination
of AT commands limited to a maximum of 40 characters. The
command string will vary depending on the needs of the
connected device. For example, some devices need DTR to be
high while others need DTR to be ignored. For a full listing as
well as parameters and defaults, refer the AT Command
appendix.
Caution: The only commands that can be used in the string are
those which do not require ALEOS. All AT Commands beginning with
an * (asterix) require ALEOS.
Tip: The model number of your modem is on the label on the top of
the case (example, Raven 1x C3211-S or Raven CDMA C3210).