Sierra Wireless RAVEN 20070914 - Manual (Page 134)

Configuration Commands
Rev 3.0B Feb.08 129
MLIST and MLISTX are configured by the fields available in
the Addr List group. AceManager automatically differentiates
between them to enter the correct command for the modem.
MLISTid=d.d.d.d
Enters an ID and IP address into the Modbus List. ID is a
decimal value (1 to 100).
• id=ID
• d.d.d.d=IP address or name
MLISTXhexid=d.d.d.d
Enters an ID and IP address into the Modbus List. ID is a
hexadecimal value (0 to 64).
• hexid=ID
• d.d.d.d=IP address or name
1x/EV-DO
This group includes commands specific to 1x and EV‐DO. If
you are not connecting to a modem which uses EV‐DO or 1x,
you will not see this group in the menu.
Figure 1-17: AceManager : 1x/EV-DO
+CTA=n
Inactivity timer, in seconds. Typical network settings cause a
link to go dormant after 10 to 20 seconds of inactivity, no
packets transmitted or received. This time can be shortened to
release the physical RF link sooner when the application only
transmits short bursts.
• n=0 : Allows the cellular network to determine the
inactivity timer.
• n= seconds (maximum 20 seconds)
$QCMIP=n
Mobile IP (MIP) Preferences. On a Mobile IP network, a device
connects to the network using PPP. During the negotiation
process the Raven is NOT required to present a username and
password to authenticate because the authentication param‐
eters are stored in the modem itself.
• n=0 : Disabled, SIP only
• n=1 : MIP preferred
• n=2 : MIP only