Sierra Wireless RAVEN 20070914 - Manual (Page 136)

Configuration Commands
Rev 3.0B Feb.08 131
+WSPC=[lock],[nnnnnn]
Service Programming Code. C3x11 and C3x11E only. Upon
successful entry of this code, all other service provisioning AT
commands may be used.
• lock=0 : OTKSL(One Time Key Subsidy Lock)
• lock=1 : MSL (Master Subsidy Lock)
• nnnnnn=6 digit unlock code
Note: If an OTKSL is used to enter provisioning mode, only the
+WIMI, +WMDN, and +WCMT commands will be allowed. All other
commands will return ERROR.
Caution: This command supports five attempts to enter the correct
service programming code. If five incorrect attempts are performed,
the ME will power down.
Once the correct SPC code is entered, the module transitions to
the Service Programming state. This state is not exited until a
commit is done (+WCMT). While in the Service Programming
state, subsequent validations of the SPC code are ignored until
the Service Programming state is reset.
+WMDN=num
Set the Mobile Directory Number (MDN). C3x11 and C3x11E
only.
• num=phone number (Valid numbers are between 10 and
15 digits in length.)
For support of Wireless Number Portability in all non‐RUIM
software versions, changes to the MDN will update the
IMSI_M portion (least significant 10 digits) of the IMSI.
Changes to the MDN will also automatically update the Access
Overload Class values unless specifically modified using the
+WAOC command. The new IMSI_M and Access Overload
Class values will not be visible in the WIMI and WAOC
commands until after the changes are committed with the
WCMT command.
+WIMI=num
Set the IMSI (MIN/MSID preceded by the country code, Inter‐
national Mobile Subscriber Identity). C3x11 and C3x11E only.
• num=MIN/MSID preceded by the country code
The MIN/MSID preceded by the country code is 15 digits in
length; MCC (3), MNC (2), MIN2 (3), MIN1 (7). For support of
Wireless Number Portability, changes to this number will NOT