Sierra Wireless RAVEN 20070914 - Manual (Page 141)

Raven 1x
136 20070914
Common AT Commands
• E ‐ Echo
• Q ‐ Quiet Mode
• &C ‐ DCD Control
• &D ‐ DTR Options
• &S ‐ DSR Options
• S0 ‐ Auto‐answer mode
• S7 ‐ Wait for Carrier
• S8 Comma Pause Time
• S9 ‐ Carrier Detect Response Time
• +IFC=x,x ‐ Enable or Disable Flow control ‐ RTS/CTS for
C3210, you will need to use a comma replacement
command
• $QCVAD ‐ Answer as a Data Call forC3210
• +CICB ‐ Answer as a Data Call for C3211
Raven LEDs in Circuit-Switched Mode
When the Raven is in Circuit‐Switched mode, the LEDs on the
front will behave differently. The Chan, Link, and Reg LEDs will
flash in tandem, like with PassThru mode, while all other
LEDs (except for Power) will be off.
Step by Step Configuration
For your convenience, these directions use pre‐configured
templates.
Table 2-2: Example for the Raven C3211
Command Components
AT*PTINIT= ATS0=1+CICB=0 AT*PTINIT=
Include this portion only if you will not be entering
the command using a AceManager. The
remainder of the example is the command string.
AT
All AT commands must start with “AT”.
S0=1+CICB=0
The string is a combination of AT Commands
limited to a maximum of 40 characters.