Output – Sharp MX-7001 User Manual
Page 117
36
OUTPUT
To select output functions and the output tray, touch the [Output] key in the base screen of copy mode. Output functions
that can be selected are sort, group, offset, staple sort, saddle stitch, and punch. All explanations of the settings below
assume that a saddle stitch finisher is installed.
(1)
[Offset Tray] key ([Center Tray] key*)
Output is delivered to the offset tray. The [Offset Tray]
key is automatically selected when the [Staple Sort] key
is selected.
* When a finisher or saddle stitch finisher is not installed,
this key is the [Center Tray] key. In this case, the offset
function cannot be used.
(2)
[Offset] key
This is used to offset each set of output from the previous
set.
The offset function operates when the checkbox is
selected
and does not operate when the checkbox is
not selected
. (The offset checkmark is automatically
cleared when the staple sort function is selected.)
☞
(3)
[Sort] key
This is used to sort (collate) output into sets.
☞
(page 38)
(4)
[Staple Sort] key
This is used to sort output into sets, staple each set, and
deliver the sets to the tray. (Note that the sets will not be
offset in the output tray.) When this function is selected,
three keys will appear for selecting the staple position.
☞
Staple sort function / Saddle stitch function
(page 39)
(5)
[Group] key
This is used to group copies by page.
☞
(6)
Output display
An icon will appear to indicate the output mode.
(7)
[Right Tray] key
Select this key to have output delivered to the right tray.
When the right tray is selected, offset, staple sort, saddle
stitch, and punch cannot be selected.
(8)
[OK] key
Touch this key to close the output screen and return to
the base screen.
(9)
[Saddle Stitch] key
This is used to staple and fold each set of copies at the
centerline.
☞
Staple sort function / Saddle stitch function
(page 39)
When this key is touched, the saddle stitch setting screen
appears. (Only when "Automatic Saddle Stitch" is
enabled in the system settings (administrator).)
(10) [Punch] key
This is used to punch holes in the output.
☞
OK
Output
Sort
Right Tray
Offset
Offset
Tray
Staple
Sort
Group
Saddle
Stitch
Punch
(6)
(7)
(8)
(3)
(4)
(5)
(9)
(10)
(1)
(2)