Sharp MX-7001 - Manual (Page 49)

49
FINISHER / SADDLE STITCH FINISHER
The finisher and saddle stitch finisher are equipped with the offset function, which offsets each set of output from the
previous set, and the staple sort function, which staples each set of output. The saddle stitch finisher is also equipped
with the pamphlet staple function, which automatically staples and folds each set of output at the centerline.
A punch module can also be installed to punch holes in output.
PART NAMES
(1) Stapler compiler
This temporarily stacks paper to be stapled.
(2) Output trays (upper tray, lower tray)
Stapled and offset output is delivered to these trays.
The trays are slidable. For large-size output (12" x 18",
11" x 17", 8-1/2" x 14", 8-1/2" x 13", A3W, A3, B4),
extend the tray.
(3) Saddle stitch tray
Stapled and folded output is delivered to this tray.
(4) Saddle stitch tray guide
This guides the output as it is delivered to the tray. Before
printing, attach the saddle stitch tray guide in the
appropriate position below for the paper size to be used.
(5) Top cover
Open this cover to remove a paper misfeed.
(6) Front cover
Open this cover to replace the staple cartridge or remove
a staple jam.
(1)
(2)
(5)
(6)
(3)
(4)
Finisher
11" x 17"/8-1/2" x 14"
(A3/B4) 8-1/2" x 11"R
(A4R)
• A paper pass unit is required to install a finisher or saddle stitch finisher.
• Do not place heavy objects on the finisher / saddle stitch finisher or press down on the finisher / saddle stitch finisher.
• Use caution when you turn on the power and when printing is taking place, as the output tray may move up and down.
• A saddle stitch finisher and a finisher cannot be installed simultaneously.