Silex technology Mini Print Server PRICOM SX-300U - Manual (Page 187)

13 Appendix
Users Manual SX
Tab Explanation
Factory
Default
Specify the authentication community name for
SNMP. This community name is authenticated when
an SNMP set request is received.
public
Specify the trap community of SNMP. This community
name is used when the print server sends a trap.
public
Specify the destination IP address of the SNMP trap.
The value is a four-part series of numbers separated by
decimal points, such as "xxx.xxx.xxx.xxx". When the
value is "0.0.0.0"(default), this item is disabled and a
trap will not be generated.
0.0.0.0
SysContact Specify the SysContact of the MIB-II object. The e-mail
address of the network administrator is used.
-
SysName Specify the SysName of the MIB-II object. The host
name or domain name of the print server is used.
-
SysLocation Specify the SysLocation of the MIB-II object. The
location of the print server is used.
-
DefaultTTL Specify the Default TTL of MIB-II object in the range of
"0 to 255". This value means the longest time of an IP
packet's existence. Usually the value should be the
default.
255
Enable Authen
Trap Select whether to allow or disallow the
"EnableAuthenTrap" of the MIB-II object. If a violation of
the community occurs "allow" is the setting, the
SNMP trap is sent to the IP address specified in
"TRAP Address".
ENABLE
Item
SNMP
MIB-II Parameters
Authentication
community
Trap Community
Trap Destination Address
SMNP Setup