Savin G1619 - Manual (Page 112)

Other Transmission Features
24
3
Dual Access
The machine can scan other messages
into memory even while sending a
fax message from memory, receiving
a message into memory , or automat-
ically printing a report. Since the ma-
chine starts sending the second
message immediately after the cur-
rent transmission terminates, the line
will be used efficiently.
Note that during Immediate Trans-
mission or when in User Tools mode,
the machine cannot scan an original.
ECM (Error Correction Mode)
This function automatically resends
data that was not transmitted suc-
cessfully using a system that complies
with international standards.
ECM requires that the receiver has
the same function.
Parallel Memory Transmission
This function dials while the original
is being scanned. Standard Memory
Transmission stores the original in
memory, then dials the destination.
Parallel Memory Transmission al-
l o w s y o u t o q u ic k ly d e t e rm i ne
whether a connection was made. In
addition, this function scans the orig-
inal faster than Immediate Transmis-
sion and is useful when you are in a
hurry and need to use the original for
another purpose.
Note
❒ You can switch this function on or
off with the User Parameters. See
p.58 “User Parameters” (Switch07,
Bit2).
Limitation
❒ Standard Memory Transmission is
used instead of Parallel Memory
Transmission in the following cas-
es.
• When the line is busy and could
not be connected to
• With Send Later
• When you store an original for
Memory Transmission while an-
o t h e r c o m m u n i c a t i o n i s i n
progress
• When two or more destinations are
specified
• When the original is set on the ex-
posure glass
Note
❒ If you press the {{{{Clear/Stop}}}} key,
the original jams, or memory be-
comes full during Parallel Memory
Transmission, the machine stops
transmitting and prints the Com-
munication Result Report. The file
is erased.
❒ Total stored page numbers are not
printed in the Parallel Memory
Transmission. Only the page num-
bers are printed, such as P.1, P.2
not 1/2, 2/2.
❒ If you run out of memory, normal
Memory Transmission takes place.
❒ File Reserve Report will not be
printed with Parallel Memory
Transmission.